Grinding twice during the interval of the number of welds
Grinding twice during the interval of the number of welds depends welding parameter and steel type. For example, if the plate thickness of 1.0 mm, then the two repair grinding between the maximum number of welds 400.
Best grinding environment
Environmental factors that affect the electric extreme grinding blade shape of the electrode grinding speed (rev / min), the welding torch pressure grinding time. The target electrode grinding grinding 1 second worn 0.1mm accumulation layer, so you want to choose the correct blade shape, speed, gun pressure grinding time. If the effect is unstable, it is recommended that the electrode the grinding device manufacturers consultation to determine the best grinding environment for your project.
Welding parameters
Some users upgrade program (current increase of 2% to 5%) were not equipped with the Welding Electrode grinding. In fact, with the electrode grinding, there is no need to increase the current.
The electric tip of grinding times
The frequency depends on the electrode end of grinding grinding parameters. Users can grinding on each electrode cap 50 to 100 times (according to the welding conditions, including welding torch, electrode shape and grinding time, etc.).
Blade life
Due to a variety of Welding Assembly parameters, such as welding torch type, material, gun pressure and the time grinding blade longevity is not easy to grasp. But there are two ways to determine this factor. First of all, the regular replacement blades. For example, some users experience determine the shortest life of a leaf blade, the shortest-life replacement. The second method is to use a welding face verification tools. After verification, the user will be able to know whether the blade grinding electrode reasonable. If the adverse effects of grinding, to remind the user needs to change the blade. In the past few years, and continue to introduce new materials and new technology in blade design, blade life has steadily extended.
Calibration device
Constantly over the past few years, the introduction of new technologies to the electrodes in the grinding process. One new product is the speed sensor. The speed sensor can help users determine the rotation of the motor grinding device. Another one is the electrode calibration device, it allows users to know whether good grinding effect.
Debris / shavings management
In the past few years, the community set off the environmental climax, car manufacturers also conform to the crowd. Past, manufacturers use a hair dryer, copper scrap in the manufacturing workshop to be blown flying everywhere. Now, many manufacturers have begun to use to collect the debris / shavings concentrated in of recycling appliances debris management device. This is to ensure the cleaning of the factory floor, but also recovery of copper scrap in response to the ecological called on.